Original Post

Hi everybody,

I was looking at the link cable stl files on the 3D models page of the site and thought it would be a fun project to try and create the link cable using the guide provided. when I loaded the files in to the slicer software the dimensions from the files were way to big. I was wondering if anyone had the correct dimensions on hand. Thanks for the help in advance.

2 Replies

Should be in mm. You can measure your link port on your VB for scale.

As mellott124 says these are in mm, if you are working in inch scale, then the models will be 25.4 times too big.

1″ = 25.4mm exactly

 

Write a reply

You must be logged in to reply to this topic.