Original Post

Has anyone followed the traces from the display connectors? I seem to have lifted the pads from a connector and I saw some vias where I could solder, but on some I noticed that there are 2 sets of vias, one under the connector and one above the connector.

3 Replies

I’m not quite sure what you’re asking… but all pins are connected between both displays except the display select (pin 2 IIRC), and maybe pins 1 and 30 (don’t remember). So you can check continuity from the other display connector if you’re trying to find a place to connect.

DogP

DogP schrieb:
I’m not quite sure what you’re asking… but all pins are connected between both displays except the display select (pin 2 IIRC), and maybe pins 1 and 30 (don’t remember). So you can check continuity from the other display connector if you’re trying to find a place to connect.

DogP

It’s where the black connector on the mainboard is. I tried to remove it and ended up with a mess. So both the left and right connectors share the exact same traces?

boom wrote:

DogP schrieb:
I’m not quite sure what you’re asking… but all pins are connected between both displays except the display select (pin 2 IIRC), and maybe pins 1 and 30 (don’t remember). So you can check continuity from the other display connector if you’re trying to find a place to connect.

DogP

It’s where the black connector on the mainboard is. I tried to remove it and ended up with a mess. So both the left and right connectors share the exact same traces?

Yes… except for the pins I mentioned above.

DogP

 

Write a reply

You must be logged in to reply to this topic.