Hello everyone!

Sorry that I didn’t post my repair process. I just had finals this week so no homework! Anyway, stay tuned for photos of my repair.

I’m back! I managed to do the via repair, but in haste I managed to rip off the connector on the mainboard and also ripped off some pads along with it. I’ll try to repair this tomorrow. Anyway here are the photos so far.

Attachments:

1. 

   20140125_1443101-scaled.jpg
   

2. 

   20140125_1443341-scaled.jpg
   

3. 

   20140125_1444361-scaled.jpg
   

4. 

   20140125_1444511-scaled.jpg
   

5. 

   20140125_1639231-scaled.jpg
   

6. 

   20140125_1639271-scaled.jpg
   

7. 

   20140125_1645411-scaled.jpg
   

Can´t wait to hear if that works. So the idea here was to solder the cables not on the original pads, but to other contact points and then you put hot glue on it so that it does not move around any more, correct?

Correct. I followed a guide made by DogP and went from there. Unfortunately I was impatient and tried to remove the connecter on the mainboard and ripped off a few pads. I’ll see if I could fix that using the same technique today.