ok i got the tool,got it open the screws were tight,and on the left display chip i dont see the red blinking ights that i should see and i am messing with the cable,and theres no intermittment display on it,i dont know if the cable is damaged or not its small,what shouodl i do now?

ok cool i dont know if i would be good at that,but do you ugys think these ones would work ? what is the correct bit size,can you look at my links and tel me if this is what i need?

here is the bit driver: http://electricquarter.com/tool-magentic-driver-p-58.html?osCsid=358f51c31dfa411e5ace897fda018bf1

here is the bit: http://www.mcmelectronics.com/product/22-1150

anyone know ? is there a way to use that bit and make it longer?

ok how long would the tool need to be to be able to reach all of the screws ? where can i get the longest one that will work ? i wanna play theis so badly lol.

ok thank you is there like a vid or pics on how to sotter the wires using the 30 gauge kynars shown in the bypass guide,i see how he did it but i just dont know where any of the wires really go and stuff i am not really sottering expert.

where can i buy the tool already made ? also i dont know much about working with the boards,and stuff. is here a repair service that can do it in case i cant figure it out ? i know intendo dont do that anymore lol.